MPLS Soft WaterCity water, wells and softener settings · Minneapolis, MN

Two named guides, every figure credited

Minneapolis Water Softener Cost: New, Repaired, Reset or Removed

Water softener cost in Minneapolis depends less on hardness than it does in most cities, because city water arrives already softened to about 5.5 grains. The bigger swings come from what the house already has: a working loop, an old unit to reset or haul away, or a private well that needs real capacity. The figures below come from HomeGuide and Angi.

Ask about my waterRead the FAQ

HomeGuide's 2025 guide puts a salt-based softener at $1,200–$3,800 installed, averaging $2,500. Angi's Minneapolis page (updated July 2026) gives an average of $1,572, with most homeowners paying $210–$6,288. A repair runs $150–$600 (HomeGuide). These are published estimates, not quotes for your home.

Water softener cost in Minneapolis, by job

Ranges published by HomeGuide (water softener cost, July 25, 2025; water softener repair cost, July 14, 2025; reverse osmosis system cost, July 14, 2025; well water filtration system cost, April 24, 2026) and Angi (water softener cost in Minneapolis, updated July 20, 2026). Use them to judge whether a bid is in a normal band; only a written quote for your house is a price.
JobTypical rangePublished byWhat moves it on Minneapolis water
Salt-based softener, installed$1,200–$3,800 (average $2,500)HomeGuide, 2025City water near 5.5 grains needs less capacity than well water
Softener installation, Minneapolis estimateAverage $1,572; most pay $210–$6,288Angi, 2026Existing loop, drain and outlet
Dual-tank softener, installed$1,700–$5,000HomeGuide, 2025Large households; rarely needed on city water
Salt-free system, installed$1,500–$4,500HomeGuide, 2025Changes how scale forms; does not remove hardness
Softener repair$150–$600 (average $430)HomeGuide, 2025Valve, float, injector or resin
Service call and inspection$40–$100, parts extraHomeGuide, 2025Resetting hardness and checking regeneration
Resin replacement$200–$400HomeGuide, 2025Age of the unit; iron fouling on well water
Removing a softener$50–$100 with disposalHomeGuide, 2025Capping the loop or leaving a bypass
Under-sink reverse osmosis, installed$300–$950HomeGuide, 2025Tank or tankless; countertop drilling
Whole-house reverse osmosis, installed$4,800–$10,000HomeGuide, 2025Storage tank and pump size
Iron or manganese filter for a well, installed$1,000–$3,500HomeGuide, 2026Iron level and pH in the well test
Hardness test strips in a cup beside a scaled kitchen faucet and spotted glasses, the test that sets water softener cost
Hardness test strips next to a faucet with mineral scale; a test of your own tap sets the size of any softener.
Inspection in Minneapolis: what's going on?

Only the local specialist gets it, to reach you about this.

Free to ask. No obligation. Many local specialists don't charge for the first visit; ask when they call.

This site is run by a referral service that is paid by the specialists it connects you with. Asking costs you nothing.

A local water treatment specialist who serves Minneapolis will call you back. Your request goes to that one independent specialist, not a list. By sending this you agree they may call or text you about it. Privacy.

What moves water softener cost in a Minneapolis house?

  • Your supply. City water averaged 94 mg/L in 2025 (Minneapolis plant record), so a modest unit handles a normal household. A private well, or a home on a supplier with harder water, needs more resin, and sometimes an iron filter ahead of the softener.
  • What is already plumbed. Many older houses already have a loop, a drain line and an outlet from an earlier softener. Reusing them is the cheapest path; adding a loop, a drain or a circuit adds labor. HomeGuide prices a dedicated circuit at $250–$900.
  • Which lines get softened. The Minnesota Department of Health notes that toilets, hose bibs and many cold taps usually do not need softened water, and some homes soften only hot water. Fewer softened lines means a smaller unit.
  • The state's rules. Minnesota requires a licensed water conditioning contractor or plumber for paid installs (Minn. Stat. 326B.55); ask whether a city permit applies and whether its fee is in the price.

Is a reset cheaper than a new softener?

Much cheaper. HomeGuide puts a service call and inspection at $40–$100 before parts, against $1,200–$3,800 for a new installed unit. On city water, a working softener that only needs its hardness setting lowered toward 5 or 6 grains, its brine tank cleaned and its regeneration checked may be the whole job. Removal, if you decide you do not want one at all, runs $50–$100 with disposal. The repair, reset or remove page lays out how to decide.

What are the yearly running costs?

HomeGuide puts salt or potassium at $50–$150 a year and maintenance at $100–$300. Angi's Minneapolis page lists annual service at $100–$300 and salt at about $50–$100 a year for a small system on city water. Each regeneration also sends brine down the drain. The Minnesota Department of Health points out that wastewater plants are not designed to remove chloride, so it ends up in lakes and streams; a correct hardness setting saves salt and does less of that.

Reading two softener bids side by side

Put the same questions to each: the hardness number the bid is built on (a test of your tap, or a guess), the grain capacity and salt setting, which lines will be softened, whether the drain keeps an air gap, which Minnesota license the installer holds, and whether a permit is included. Ask for the equipment warranty terms in writing. A bid that assumes 20-grain water for a house on city water is sized for somebody else's water.

Cost questions

How much is a water softener in Minneapolis?

Angi's Minneapolis page, updated July 2026, gives an average installed cost of $1,572, with most homeowners paying between $210 and $6,288. HomeGuide's 2025 national guide puts a salt-based softener at $1,200 to $3,800 installed. Capacity is one of the cost factors HomeGuide names, and city water near 5.5 grains rarely calls for a large unit.

What does it cost to have an old softener removed?

HomeGuide puts removal at $50 to $100 including disposal. Ask whether the loop will be capped or the bypass left in place for a future owner. Removal makes the most sense on city water when the softener is old, set far too high or no longer worth repairing.

Is reverse osmosis cheaper than a softener?

An under-sink reverse osmosis unit is, at $300 to $950 installed in HomeGuide's 2025 guide, but it treats drinking water at one tap rather than the whole house. Whole-house reverse osmosis runs $4,800 to $10,000. On Minneapolis water, people usually choose RO for taste or to cut trace compounds further, not for hardness.

What is your water doing?

A sentence is plenty: a softener that runs out of salt too fast, spots that will not go away, a private well, a taste you do not like. One independent water treatment specialist who works in Minneapolis will get in touch.

What's going on?

Only the local specialist gets it, to reach you about this.

Free to ask. No obligation. Many local specialists don't charge for the first visit; ask when they call.

This site is run by a referral service that is paid by the specialists it connects you with. Asking costs you nothing.

A local water treatment specialist who serves Minneapolis will call you back. Your request goes to that one independent specialist, not a list. By sending this you agree they may call or text you about it. Privacy.

Request Ask about my waterSee prices